IBM IntelliStation Z Pro Type 6866 User Manual page 81

Removing a RIMM or C-RIMM
To remove a C-RIMM or RIMM:
Before you begin
Turn off the computer and all other connected devices.
Disconnect all cables attached to the computer and remove the
computer cover (see "Removing the cover and front bezel" on
page 57).
If your computer came with an air baffle, you may need to lift it
out to access parts of the system board. See "Removing the air
baffle" on page 59 for more information.
Attention: The presence of 5 V standby power might result in
damage to your hardware unless you disconnect the power cord
from the electrical outlet before opening the computer cover.
1. To locate the RIMM connectors inside your computer, see "Identifying
parts on the system board" on page 60 and "Locating components on
the memory card" on page 62.
2. Press the tab on the front fan and push the adapter guide latch toward
the front of the chassis until it snaps into place.
3. Disconnect the power and hard disk drive fan cables on the memory
card.
Chapter 5. Installing options
65