IBM IntelliStation Z Pro Type 6866 User Manual page 83

Installing a RIMM or C-RIMM
Before you begin
Read the instructions that come with the new system memory.
Turn off the computer and all other connected devices.
Disconnect all cables attached to the computer and remove the
computer cover (see "Removing the cover and front bezel" on
page 57).
To install a RIMM or C-RIMM:
1. Touch the static-protective package containing the RIMM to any
unpainted metal surface in the computer, and then remove the RIMM or
C-RIMM.
2. Position the RIMM or C-RIMM above the connector so that the two
notches on the bottom edge of the module align properly with the
empty connector.
Note: Pay attention to the orientation of the notches on the connectors
and RIMMs. Adjacent connectors might not have the same
orientation on the memory card.
3. Firmly push the module straight down into the connector until the
retaining clips pop up and fit snugly around both ends of the module.
Notches
4. Place the memory card back in the slot on the system board and
reattach the power and hard disk drive fan cables to the connectors on
the memory card.
5. Release the adapter guide latch on the front fan.
6. Go to the device-record form in Appendix C, "Computer records" on
page 147 and record this installation.
Chapter 5. Installing options
67