Maintaining the printer
•
If the printer has a caster base, then carefully roll it to the new location. Use caution when passing over
thresholds and breaks in flooring.
•
If the printer does not have a caster base but is configured with optional trays, then lift the printer off the
trays. Do not try to lift the printer and the trays at the same time.
•
Always use the handholds on the printer to lift it.
•
Any cart used to move the printer must have a surface able to support the full footprint of the printer.
•
Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
•
Keep the printer in an upright position.
•
Avoid severe jarring movements.
•
Make sure that your fingers are not under the printer when you set it down.
•
Make sure that there is adequate clearance around the printer.
Note: Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
For shipping instructions, go to
Saving energy and paper
Setting up power saver modes
1
From the control panel, navigate to:
> Settings >
2
Do one or more of the following:
For Eco Mode
a
Select Eco Mode, and then press
b
Select a setting, and then press
For Sleep mode
a
Navigate to:
Timeouts >
b
Set the idle time before the printer enters Sleep mode, and then press
http://support.lexmark.com
> Device >
> Power Management >
.
.
> Sleep Timeout >
or contact customer support.
.
55