Faceplate Display Information; Table 8 C300 Controller Faceplate Display Indications - Honeywell C300 User Manual

LED Indication
¼ second
AND faceplate display is blank.
( i.e. ¼ sec ON, ¼
sec. OFF)
OFF
AND faceplate display is frozen
(a blank or frozen or blank.
display)

Faceplate display information

The four-character display on the C300 faceplate shows a variety of information
depending upon the controller state and status:

During controller power-up, the display indicates the controller's Power-On Self Test
execution and software version.

The controller's operating state the display shows in a rotating display the FTE
Device Index, CEE state, and soft failures (such as redundancy, communications, or
diagnostic faults).

The controller's redundancy role and synchronization status.

Fault codes when the controller ceases normal operation due to a major fault.
Table 8 includes a listing and descriptions of the various indications of the C300
Controller display.

Table 8 C300 Controller faceplate display indications

C300 Faceplate
Display
(####) Communication Failure - No effect on controller state,
See Note 1 shown on Control Builder forms and Station displays.
Tnnn POST test number - Transient state, No CDA.
-BP- Controller in BOOTP mode waiting for IP address from
BOOTP Server - Transient state, No CDA.
-TS- Controller is attempting connection to configured time
R500
April 2017
Status/Description
Indicates...
Series 8 C300 Controller User's Guide
Honeywell
7. C300 Controller Operation
7.2. C300 faceplate indicators/displays
Indicates: Hardware Watchdog Timer
expired or other major fault.
Indicates: Fault (Hardware watchdog
timeout or hardware failure)
(PCMSTATE)
Control Builder
OFFNET
N/A
BOOTING
BOOTING
C300 State
shown on
Station and
displays
181