C300 Configuration Form Reference; C300 Controller Block; Main Tab - Honeywell C300 User Manual

5. C300 Configuration Form Reference

This chapter describes the summary of the user visible parameters for a C300 Controller
and its associated blocks, (Secondary C300, CEEC300, and IOLINK blocks). The
parameters are grouped according to the tab where they reside on the configuration form.
For more details on these parameters see the Control Builder Parameter Reference.
The following table provides the sections covered in this chapter. Click the topic to view
it.

C300 Controller block

Secondary C300 block
CEEC300 function block
IOLINK block
Note: Since migration is not supported in this release, parameters related to OPM are not
applicable.
5.1 C300 Controller Block

Main tab

The Main Tab is used to configure (and display configuration of) the C300 Controller.
Refer to the To configure a C300 Controller block
Controller block. The Main tab contains most of the parameters that must be configured
when setting up a C300 Controller. It also displays the important states of the C300
Controller and supports the key commands associated with C300 Controller operation.
Location and Redundancy configuration can be entered only in the Project Tree. The
following table summarizes the parameter data you can monitor and/or configure on the
Main tab of the configuration form for the selected C300 block.
R500
April 2017
Topic
Series 8 C300 Controller User's Guide
Honeywell
for the steps to configure a C300
87