Honeywell C300 User Manual page 188

7. C300 Controller Operation
7.2. C300 faceplate indicators/displays
C300 Faceplate
Display
source, or time server is not available - Transient state, No
CDA.
COMM Controller not able to communicate with other nodes.
See Note 2
TEST Factory Test mode - Non product state, No CDA.
FAIL Failure in Module - No CDA.
See Note 3
ALIV Boot mode with no valid application image - No CDA
RDY Boot mode with application image - No CDA
LOAD Firmware load in progress - No CDA
PROG Firmware flash in progress - No CDA
NODB Application mode with no database - CDA present
NOEE Application node with no CEE, but C300 FB present with
CDA. This is a transient state during loading C300 FB or
when deleting CEE FB/C300 FB
IDLE Application mode with database loaded, all EEs good with
controller in IDLE - CDA present
OK Application mode with database loaded, all EEs good with
controller in RUN - CDA present
BKUP Application mode with database loaded, all EEs good,
module is secondary - CDA present
SF One or more soft fail conditions are present in the C300
See Note 4 Controller. This state is independent of either CEE state
or Redundancy role.
Note 1: (####) - This symbol does not appear on the C300 Controller faceplate display. It appears
on Control Builder and operator (Station) displays representing the C300 Controller to indicate
that the C300 Controller is OFFNET and this data is not available at this time. Controller will
continue to display the existing or changing faceplate display indication per the current controller
state. As a result of communication failure, CDA will return OFFNET as C300 Module State.
182
Indicates...
Series 8 C300 Controller User's Guide
Honeywell
C300 State
(PCMSTATE)
shown on
Station and
Control Builder
displays
OFFNET
TESTING
FAILED
ALIVE
PIREADY
LOADING
LOADING
NOTLOADED
NOEE
CEEIDLE
CEERUN
BACKUP
SOFTFAIL
R500
April 2017