Series 8 Control Hardware Installation Requirements; C300 Controller Installation; C300 Controller Assembly - Honeywell C300 User Manual

3. C300 Controller Installation and Upgrades

3.2. C300 Controller installation

ESD HAZARD
Electrostatic discharge can damage integrated circuits or semiconductors if
you touch connector pins or tracks on a printed wiring board. Follow these
guidelines when you handle any electronic component:

Touch a grounded object to discharge static potential

Wear an approved wrist-strap grounding device

Do not touch the wire connector or connector pins

Do not touch circuit components inside a component

If available, use a static safe workstation

When not in use, keep the component in its static shield box or bag
WARNING
Unless the location is known to be non-hazardous, do not connect or
disconnect cables while the control system is powered.

Series 8 control hardware installation requirements

Refer to Planning Your Series 8 Control System section in the Control Hardware
Planning Guide for details.
3.2 C300 Controller installation

C300 Controller assembly

The C300 Controller consists of an Input/Output Terminal Assembly (IOTA) board and
the controller module which is housed within a plastic cover and is mounted on the IOTA
board. The Controller assembly is installed in a control cabinet on vertically-mounted
channels specifically for Series 8 control hardware. The following figure shows the
features of the C300 Controller IOTA board.
32 Series 8 C300 Controller User's Guide
Honeywell
R500
April 2017