Vari Pitch; Solo/Mute; Preview; Midi - Roland VS-2480 Owner's Manual

28—UTILITY Menu Parameters
FADE LENGTH
You can set the length of the crossfade described in FADE CURVE on the previous
page. You can select 2ms, 10ms, 20ms, 30ms, 40ms or 50ms. The default setting is 10ms.

VARI PITCH

VARI PITCH Sw and VARI PITCH
The two VARI PITCH parameters are explained in "Vari Pitch Playback" on Page 182.

SOLO/MUTE

SOLO/MUTE TYPE
When you mute a channel—or when it's silenced as the result of another channel being
soloed—you can set exactly where in the VS-2480 its signal is stopped. This is
determined by the setting of the SOLO/MUTE TYPE parameter. When it's set to:
•
•

PREVIEW

SCRUB LENGTH
This parameter is explained in "Setting Scrub Times" on Page 185.
PREVIEW TO LENGTH and PREVIEW FROM LENGTH
These parameters are described in "Setting the PREVIEW TO and FROM Times" on
Page 184.

MIDI

The VS-2480's MIDI parameters and operations are described in Chapter 24, starting on
Page 299. See the VS-2480 Owner's Manual index for page numbers of specific parameter
references.
368
All BUS Send—the signal is stopped before it's sent to any Aux or Direct busses or
the MASTER mix bus. It's therefore not sent to the VS-2480's effects or to outputs
via Aux or Direct busses.
MIX BUS Send—the signal is stopped before it goes to the MASTER bus only. It's
still sent to the Aux and Direct busses, and thus to internal effects and/or outputs.
www.rolandus.com Roland VS-2480 Owner's Manual
UTILITY menu
F5 (MIDI)