Don't Stop; Turning Off The Vs-2480 - Roland VS-2480 Owner's Manual

4—Setting Up and Basic Operations
5. Press SCENE again, and then 2 on the keypad to recall Scene 02—AcIntro Dflt. The
6. Press ZERO and then PLAY to hear what's been added to the project's introduction.
7. Try out the other scenes in "What You Don't Know."
To learn about storing scenes, recalling them and more, see "Scenes" on Page 144.

"Don't Stop"

Your hard drive also contains a second demo project, "Don't Stop," by Teddy Riley. To
learn how to load this demo project, see "Loading a Project" on Page 95.

Turning Off the VS-2480

It's important the you don't simply flip the VS-2480's POWER switch to turn it off—
always use the procedure below to prevent damage to your data.
If you'd like to restart the VS-2480—perhaps while troubleshooting a problem—use the
procedure below as well.
Turning Off the VS-2480
1. Hold down SHIFT, and press STOP•SHUT/EJECT. The following dialog appears:
2. If you wish to turn off or restart the VS-2480, press ENTER/YES. If not, press EXIT/
3. If you've made changes to the currently loaded project you'd like to preserve, press
If you're shutting down the VS-2480 when a factory demo song—or any other protected
project—is loaded, you won't be prompted to store the current song.
4. If you'd like to restart the VS-2480, hold down SHIFT and press PLAY•RESTART—
If you need to move the VS-2480 after shutting it down, wait 30 seconds or so to give its
hard drive a chance to stop spinning in order to avoid damaging it.
80
display changes to show that this scene uses different V-Tracks than Scene 01.
NO to cancel the operation. If you press ENTER/YES, a dialog like this one appears:
ENTER/YES. If you haven't, press EXIT/NO.
In either case, the VS-2480 takes a few moments to prepare to shut down—and to
save your project if you pressed ENTER/YES in Step 3. When the VS-2480 is ready
to be powered off, the following message appears:
the VS-2480 begins its power-up sequence. If you'd like to shut down the
VS-2480, flip its rear-panel POWER switch to its Off position.
www.rolandus.com
The name of the
currently loaded project.
The project's sample rate and
recording mode (Page 98).
Roland VS-2480 Owner's Manual