Working In The Vs-2480 Mastering Room; Navigating To The Mastering Room; Selecting The Mastering Room Operating Mode; Selecting The Mastering Tracks' Recording Mode - Roland VS-2480 Owner's Manual

Working in the VS-2480 Mastering Room

Navigating to the Mastering Room

1. While holding down SHIFT, press CD-RW/MASTERING. The

Turning On the Mastering Room

To turn on the Mastering Room:
1. Set the MASTERING ROOM on/off switch to On.
2. To de-activate the Mastering Room, set its switch to Off.
When the Mastering Room is turned on, the CD-RW/MASTERING button flashes.

Selecting the Mastering Room Operating Mode

The Mastering Room's operating mode is determined by the setting of its STATUS
parameter. You can select:
•
•

Selecting the Mastering Tracks' Recording Mode

When the CDR Rec Mode parameter is turned on, your mastering tracks are recorded
as disk image files that can be immediately burned to an audio CD (Page 340). When it's
turned off, the mastering tracks are recorded using the project's recording mode.
Typically, you'll want to set CDR Rec Mode to On. Set CDR Rec mode to Off when you
need to master your mix in stages to get the most from limited effect resources, as
described in "Stretching Effects" on Page 346.
When you're mastering a project that was recorded using CDR mode, the CDR Rec
Mode parameter's value makes no difference—the mastering tracks are recorded using
CDR mode in any event.
Roland VS-2480 Owner's Manual
MASTERING ROOM screen appears.
Play—to play back already recorded mastering tracks.
Record—to record new mastering tracks.
27—Mastering and CD-R/RW Operations
Mastering room
parameters
Project playlist
Navigation buttons
www.rolandus.com
CD-RW
SHIFT
MASTERING
+
343