Roland VC-2 Owner's Manual page 46

Effects List
Type Cabinet
MIDDLE open back enclosure
JC-120 open back enclosure
BUILT IN 1 open back enclosure
BUILT IN 2 open back enclosure
BUILT IN 3 open back enclosure
BUILT IN 4 open back enclosure
BUILT IN 5 open back enclosure
BG STACK 1 sealed enclosure
BG STACK 2 large sealed enclosure
MS STACK 1 large sealed enclosure
MS STACK 2 large sealed enclosure
METAL large double stack
STACK
Recommended combination of pre-amp and speaker
Amp type Speaker type
BG LEAD BG STACK 1–2, MIDDLE
MS1959 II BG STACK 1–2, METAL STACK
MS1959 I+II BG STACK 1–2, METAL STACK
SLDN LEAD BG STACK 1–2, METAL STACK
METAL 5150 BG STACK 1–2, METAL STACK
METAL LEAD BG STACK 1–2, METAL STACK
OD-2 TURBO BUILT IN 1–4
DISTORTION BUILT IN 1–4
FUZZ BUILT IN 1–4
07: Auto Wah
Wah is an effect that modifies the frequency characteristics of
a filter over time, producing a unique tone. The wah effect can
change in relation to the volume of the input signal, and/or
cyclically.
Parameter Value
Filter Type LPF, BPF
Polarity DOWN, UP
Frequency 0–127
Peak 0–127
Trigger Sens 0–127
46
Speaker Microphone
12 x 1 dynamic
12 x 2 dynamic
12 x 2 dynamic
12 x 2 condenser
12 x 2 condenser
12 x 2 condenser
12 x 2 condenser
12 x 2 condenser
12 x 2 condenser
12 x 4 condenser
12 x 4 condenser
12 x 4 condenser
Description
Type of filter
LPF: The wah effect will be applied
over a wide frequency range.
BPF: The wah effect will be applied
over a narrow frequency range
When using the volume of the in-
put signal to control the wah effect,
this setting determines whether the
frequency of the filter will be
moved upward (UP) or downward
(DOWN).
Adjusts the frequency at which the
wah effect will apply.
Adjusts the amount of the wah ef-
fect that will occur in the range of
the center frequency.
Set a higher value for Q to narrow
the range to be affected.
Adjusts the sensitivity with which
the wah effect is controlled.
Parameter Value
Rate 0.05–10.0 Hz,
note
Depth 0–127
Ps Low Freq 50–4000 Hz
Ps Low Gain -15– +15 dB
Ps Hi Freq 2000–20000 Hz
Ps Hi Gain -15– +15 dB
08: Humanizer
This adds a vowel character to the sound, making it similar to
a human voice.
Parameter Value
Overdrive OFF, ON
Sw
Drive 0–127
Vowel 1 a, e, i, o, u
Vowel 2 a, e, i, o, u
Rate 0.05–10.0 Hz,
note
Depth 0–127
Trigger Sens -60–0 dB, LFO
Ps Low Freq 50–4000 Hz
Ps Low Gain -15– +15 dB
Ps Hi Freq 2000–20000 Hz
Ps Hi Gain -15– +15 dB
Description
Frequency of modulation
Depth of modulation
Frequency of the low range
Gain of the low range
Frequency of the high range
Gain of the high range
Description
Turns Drive on/off.
Degree of distortion
First vowel
Second vowel
Frequency at which the two vowels
will be switched
Effect depth
With a setting of 0, it will be fixed at
Vowel 1.
Level at which the two vowels will
be switched
-60–0 dB: When the specified level
is exceeded, the sound will change
to the other vowel at the frequency
(speed) specified by Rate.
LFO: The two vowel sounds will al-
ternate at the frequency specified
by Rate, regardless of the level.
Frequency of the low range
Gain of the low range
Frequency of the high range
Gain of the high range