Selecting Patches With The Value Dial; Selecting Patches From The List; Selecting Patches With Patch Palette - Roland V-Card VC-1 D-50 Owner's Manual

Selecting Patches with the VALUE dial

fig.03-04e(PatchNumber)
1.
Make sure the PATCH TOP screen is displayed. If the PATCH
TOP screen—shown right—is not displayed, press [EXIT] once or
twice until the PATCH TOP screen appears.
2.
Play the keyboard to hear what the selected patch sounds like. To
change to a different patch, touch the Patch number to highlight
it, and then turn the VALUE dial or press [INC/+], [DEC/-]. At this
time you can switch more rapidly by holding down [SHIFT] while
you perform these operations.

Selecting Patches from the List

You can easily find the desired patch by selecting it from the patch list.
1.
Make sure the PATCH TOP screen is displayed. If the PATCH TOP screen is not displayed, press [EXIT]
once or twice until the PATCH TOP screen appears.
2.
Touch <List> in the upper left area of the display. The PATCH List window appears.
fig.03-05(PatchList)
3.
Select a patch from the list. Either turn the VALUE dial or use
[INC/+], [DEC/-] to select a patch. You can also select a patch by
touching it on the display.
4.
To view higher-numbered patches, touch <31-48>–<71-88>,
located at bottom of the screen. To view other Patch banks, touch
<Pre1>–<Pre6>, <Int1>–<Int8>, located at either side of the
screen.
5.
Touch <OK>. The patch is selected and the PATCH LIST window
closes.

Selecting Patches with Patch Palette

You can select patches of currently selected Patch Bank instantly by simply pressing NUMBER [1]–[8].
fig.03-06
1.
Make sure the PATCH TOP screen is displayed.
2.
Press NUMBER [1]–[8] to select a patch. To switch banks, press [BANK-], [BANK+].
Try Out the Sounds
Patch number
13