Table of Contents
Advertisement
Transferring Patches To and From the D-50/550
Using the D-550
1.
Use a MIDI cable to connect the VariOS's MIDI OUT connector to the D-550's MIDI IN connector.
2.
Set the D-550 and V-Synth XT to the same MIDI channel (the basic channel; p. 73).
3.
Turn the Memory Protect of the D-550 to OFF.
3-1.
Press the D-550's [TUNE] button.
3-2.
Select "Protect" with the [
4.
Enable reception of bulk load data on the D-550.
4-1.
Press the D-550's [DATA TRANS] button.
4-2.
Select "(B.Load)" with the D-550's [
while holding the [DATA TRANS] button.
4-3.
Press the [ENTER] button again.
fig.04-05a
5.
Turn the Exclusive Sw of the V-Synth XT to On.
5-1.
Press [MODE].
5-2.
Touch <SYSTEM>.
5-3.
Select "Exclusive Sw," then turn the V-Synth XT's VALUE
dial to specify On.
6.
Press [MODE] on the V-Synth XT. The MODE MENU window
appears.
7.
Touch <DATA TRANSFER>. The DATA TRANSFER screen
appears.
fig.04-06(LCD_DataTrans_BulkDump)
8.
Touch <B.Dump> in the left of the screen. The MIDI Bulk Dump
screen appears.
9.
Modify the value by either turning the VALUE dial or pressing
[INC/+] or [DEC/-].
Source Bank
Selects the Patch Bank in the VC-1 with the patch data to transfer
to the D-50.
Value: I1 – I8, P1 – P6
34
3-2
3-2
3-1
4-2
] or [
] buttons, and turn it OFF with the [VALUE].
] or [
] buttons, then press the [ENTER] button
4-2
4-1
4-3
4-2
Advertisement
Table of Contents
