Try Out the Sounds
Turning On the Power
To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and
turn off the power on all devices before making any connections.
fig.03-01e(ConnectionImage)
1.
Before hooking anything up, make sure that the power on all of your gear is
turned OFF.
2.
Connect the V-Synth XT to your amp/speaker system.
3.
Turn on the V-Synth XT's Power switch.
4.
Turn on the power for any connected amplifiers or speakers.
5.
After the V-Synth XT has started up, press the [V-CARD] button and touch "D-
50" (VC-1) in the screen that appears. The VC-1 Startup screen appears.
* When you turn on the power, the V-Card that was most recently started will start up.
6.
Wait for the VC-1 to start up. When it has started up normally, a screen like the following will appear. The
display shows the selected Patch.
fig.03-02e(Card&LCD_default)
Patch number
Key mode
Tone name
Patch name
Split point
The volume balance of the Upper & Lower Tone
Mixer, etc.
Monitor Speakers
Power amp
11