Roland V-Card VC-1 D-50 Owner's Manual page 61

Bender Mode Example:
• If the Bender range is set to 12 (1 octave), and the Keyfollow (Pitch) of WG is set to 2, the
maximum pitch change caused by moving the Bender Lever is 2 octaves.
• When the Keyfollow (Pitch) of WG is set to zero, there is no pitch change caused by the
Bender lever.
TVF (Time Variant Filter)
TVF
fig.09-30(LCD_TVF/TVF)
fig.09-31e(CutoffFrequency)
Freq (Cutoff Frequency)
Sets the cutoff point of the TVF. As you lower the value, higher
frequencies are removed and the waveform gradually become an
approximation of a sine wave, then the sound will finally fade
out.
Value: 0–100
100
Frequency
Cutoff Point Frequency
Cutoff Point Frequency
0 Cutoff Point Frequency
Tone Parameters
61