Program Change; Song Position Pointer; Song Select; System Realtime Message - Roland Edirol PCR-30 Owner's Manual

Program change

Status 2nd byte
CnH ppH
n = MIDI channel number:
pp = Program number:
* Transmitted in Program change mode.
Channel pressure
Status 2nd byte
DnH vvH
n = MIDI channel number:
vv = Channel pressure:
Pitch bend change
Status 2nd byte
EnH llH
n = MIDI channel number:
mm, ll = Pitch Bend value:
* Transmitted by rightward/leftward operation of the BENDER lever in Play
mode.
Channel mode messages
In addition to the channel mode messages that can be transmitted in Panic mode,
the PCR-30/50/80 lets you assign any channel voice message to any controller and
transmit it.
Channel mode messages
Status 2nd byte
BnH ccH
n = MIDI channel number:
cc = controller number:
vv = control value:
All sounds off (Controller number 120)
Status 2nd byte
BnH 78H
n = MIDI channel number:
* Transmitted in Panic mode.
Reset all controllers (Controller number 121)
Status 2nd byte
BnH 79H
n = MIDI channel number:
* Transmitted in Panic mode.
All notes off (Controller number 123)
Status 2nd byte
BnH 7BH
n = MIDI channel number:
* Transmitted in Panic mode.
0H – FH (Ch.1 – 16)
00H – 7FH (prog. 1 – prog. 128)
0H – FH (Ch.1 – 16)
00H – 7FH (0 – 127)
3rd byte
mmH
0H – FH (Ch.1 – 16)
00 00H – 40 00H – 7FH 7FH
(-8192 – 0 – +8191)
3rd byte
vvH
0H – FH (Ch.1 – 16)
78H – 7FH
00H – 7FH
3rd byte
00H
0H – FH (Ch.1 – 16)
3rd byte
00H
0H – FH (Ch.1 – 16)
3rd byte
00H
0H – FH (Ch.1 – 16)
System common message
On the PCR-30/50/80 you can assign the following system common messages to
any controller and transmit them.
MTC quarter frame
Status 2nd byte
F1H mmH
mm = Message type/value

Song position pointer

Status 2nd byte
F2H mmH
mm, ll = Song position:

Song select

Status 2nd byte
F3H mmH
mm = Song number:
Tune request
Status
F6H

System realtime message

In addition to the Active Sensing messages that are transmitted constantly, the
PCR-30/50/80 allows you to assign the following system realtime messages (other
than Active Sensing) to any controller and transmit them.
Start
Status
F8H
* Transmitted if the System setting F8 CLOCK is ON.
Start
Status
FAH
Continue
Status
FBH
Stop
Status
FCH
Active sensing
Status
FEH
* Transmitted at intervals of approximately 250 ms.
* Cannot be assigned to a controller.

System reset

Status
FFH
MIDI implementation
3rd byte
llH
00 00H - 7F 7FH (0-16383)
00 00H - 7F 7FH (0-16383)
175