Roland Edirol PCR-30 Owner's Manual page 15

5
close the System Properties dialog box.
Click [OK] to
6
Exit all currently running software (applications).
Also close any open windows. If you are using virus checking or similar
software, be sure to exit it as well.
7
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive of your computer.
8
Click the Windows start button. From the menu that appears, select
"Run...".
Open the "Run..." dialog box.
fig.2-3_30
9
In the dialog box that appears,
input the following into the
"Open" field, and click [OK].
D:\Driver\USB_XP2K\SETUPINF.EXE
* The drive name "D:" may be different for your system. Specify the drive name of your
CD-ROM drive.
10
The SetupInf dialog box will appear.
You are now ready to install the driver.
11
Use the USB cable to connect the PCR-30/50/80 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
PCR-30/50/80.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the PCR-30/50/80 to your computer.
12
Set the PCR-30/50/80's power switch to the ON position.
Near the task bar, your computer will indicate "Found New Hardware".
Please wait.
Installing & Setting Up the Driver (Windows)
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
15