Controller Settings - Roland Edirol PCR-30 Owner's Manual

Edit mode (EDIT)

Controller settings

You can assign the following functions to a controller.
* After you have modified the controller settings, perform the "SAVE" (p. 148) operation as needed. If you
turn off the power without executing "SAVE", your changes will be lost.
NOTE
AFTERTOUCH
CONTROL CHANGE
PROGRAM CHANGE
RPN
NRPN
SYSTEM Ex.
TEMPO
NO ASSIGN
A Copy function is also available. For the procedure, refer to "ASSIGN COPY" (p. 147).
* For NOTE, AFTERTOUCH, CONTROL CHANGE, PROGRAM CHANGE, RPN, NRPN, and
SYSTEM Ex., the rightmost digit (third place) in the display is a number that indicates the mode (Basic mode
or Advanced mode).
* If you want to assign a single-byte system message (system realtime message, tune request) or a freely
specified message of up to 24 bytes, refer to "SYS EX. ASSIGN" (p. 140).
How Basic mode and Advanced mode differ
Each assignment can be made either in Basic mode or Advanced mode.
Use the mode that is appropriate for your purpose.
•Basic mode
•Advanced mode A greater number of steps are required, but you can specify more
126
"NOTE ASSIGN" (p. 127)
"AFTERTOUCH ASSIGN" (p. 129)
"CONTROL CHANGE ASSIGN" (p. 132)
"PROGRAM CHANGE ASSIGN" (p. 135)
"RPN/NRPN ASSIGN" (p. 138)
"RPN/NRPN ASSIGN" (p. 138)
"SYS EX. ASSIGN" (p. 140)
"TEMPO ASSIGN" (p. 146)
"NO ASSIGN" (p. 146)
You can make assignments easily, with the minimum number of steps.
parameters and make more sophisticated assignments.