Setting The Program Change Map - Roland GT-8 Owner's Manual

Chapter 8 Using the GT-8 with External MIDI Devices Connected
fig.08-200d
2. Transmit the data from the external MIDI device.
The following appears in the display when the GT-8
receives the data.
fig.08-210d
The following appears in the display when the GT-8
finishes receiving the data.
fig.08-220d
At this stage, even more data can be received.
3. Press [EXIT] to quit Bulk Load.
After you press [EXIT], "Checking..." appears in the
display, indicating that the GT-8 is checking the received
data. When the check is completed, the Play screen
returns to the display.

Setting the Program Change Map

When switching patches using Program Change messages
transmitted by an external MIDI device, you can freely set
the correspondence between Program Change messages
received by the GT-8 and the patches to be switched to in the
"Program Change Map."
* When setting MIDI Omni Mode (p. 80) to "Omni Off," be
sure to have the MIDI Rx Channel (p. 80) set beforehand to
the match the transmit channel of the external MIDI device.
fig.08-230
1. Press [SYSTEM], then press PARAMETER [
[ ] so that "MIDI: Map Select" is displayed.
fig.08-240d
2. Rotate the PATCH/VALUE dial to select "Prog."
* You cannot set the Program Change Map when "Fix" is
selected (it is not displayed).
* See below for more on "MID Map Select."
3. Press PARAMETER [
Map" appears in the display.
fig.08-250d
Program
Bank Select
Number
Number
4. Press PARAMETER [
and rotate the PATCH/VALUE dial to set the received
Program number and the corresponding patch number.
* Use this same procedure to select Bank Select Numbers.
* When using only Program Change messages to make program
changes, without using Bank Select messages, set the Program
number (1–128) when the Bank Select number is "0."
1,4 2 3
6 1
]
] until "MIDI: Program
Patch
Number
] [ ] to move the cursor,
83