Specifying The Port - Roland Edirol PCR-30 Owner's Manual

Specifying the port

When you are making Assign settings (p. 41) in Edit mode and have selected Advanced mode, you
must specify the USB port to which the message assigned to the controller will be sent when using
a USB connection.
1. Press a key [1]–[3] to select the port.
1
2
3
2. Press the [ENTER] button.
* If you are using the PCR-30/50/80 with a MIDI connection, the messages will be transmitted from the
MIDI OUT connector regardless of this port setting.
About the ports when using a USB connection
The ports correspond to the PCR-30/50/80 as follows.
fig.pcr-port
PCR-30/50 USB Driver
MIDI OUT device (port name)
EDIROL PCR MIDI OUT
EDIROL PCR
MIDI IN device (port name)
EDIROL PCR MIDI IN
EDIROL PCR 1
EDIROL PCR 2
MIDI OUT device
PCR MIDI OUT
( Mac OS 9/8 : PCR MIDI IN, OUT )
PCR
(Mac OS 9/8 : PCR 1)
MIDI IN device
PCR MIDI IN
( Mac OS 9/8 : PCR MIDI IN, OUT )
PCR 1
PCR 2
PORT 1 Messages will be sent to "PCR 1."
PORT 2 Messages will be sent to "PCR 2."
PORT 1,2 Messages will be sent to both "PCR 1" and "PCR 2."
PCR-30/50
USB
Bulk reception
PORT 1
PORT 2 /
Bulk transmission
If you specify PCR MIDI OUT as the output port for your sequencer software, the
MIDI messages will be sent from the MIDI OUT connector of the PCR-30/50/80.
This is the Bulk reception port. When receiving bulk data into the PCR-30/50/80,
specify PCR as the output port for your sequencer software.
If you specify PCR MIDI IN as the input port for your sequencer software, MIDI
messages from the MIDI IN connector of the PCR-30/50/80 can be received.
This is the port at which messages from the keyboard, BENDER lever, and control-
lers will be input.
The keyboard, BENDER lever, and controllers will be mapped to PCR 1 and/or
PCR 2 according to the port setting.
You may find it convenient to specify PCR 1 for messages used to play a software
synthesizer or for realtime recording on a sequencer track, and specify PCR 2 for
messages used to control the sequencer, such as sequencer play/stop or track fader
control. PCR 2 is the bulk transmission port. When transmitting bulk data from the
PCR-30/50/80, specify PCR 2 as the input port for your sequencer software.
Convenient functions
* As seen from the PCR-30/50/80, each
section of the diagram does the following.
Bulk reception
This section receives bulk data
PORT 1
Of the keyboard, bender level, and
controllers, those assigned to PORT 1
are transmitted from here
PORT 2
Of the keyboard, bender level, and
controllers, those assigned to PORT 2
are transmitted from here
Bulk transmission
This section transmits bulk data
159