Roland Edirol PCR-30 Owner's Manual page 142

Edit mode (EDIT)
13
In the case of Advanced mode 4, specify the upper and lower limits.
14
Specify the output port. ( "Specifying the port" (p. 159))
15
If you are making an assignment for a button, specify the button mode. ( "Specifying the
button mode" (p. 158))
Here are some examples of inputting various actual system exclusive messages.
GM2 System On
F0 7E 7F 09 03 F7
Here's how to assign a GM2 System On system exclusive message in Basic mode.
1. Press the [EDIT] button.
The display will indicate "EDT".
2. Slightly move the controller to which you want to assign the system exclusive
message. In the case of a button, press that button.
The display will indicate the number of the selected controller.
3. Confirm what's indicated, and press the [ENTER] button.
4. Press the [SYSTEM Ex.] key.
The display will indicate "SE0".
5. Confirm what's indicated, and press the [ENTER] button.
The display will indicate "F0", which is the first byte (beginning status) of a system exclusive
message. This cannot be changed. (This cannot be changed.)
6. Confirm what's indicated, and press the [ENTER] button.
7. Use the [7] and [E] keys to input the second byte "7E".
8. Confirm what's indicated, and press the [ENTER] button.
9. Use the [7] and [F] keys to input the third byte "7F".
10. Confirm what's indicated, and press the [ENTER] button.
Input the fourth and fifth bytes in the same way.
11. Finally, use the [F] and [7] keys to input the ending status byte "F7".
12. Confirm what's indicated, and press the [ENTER] button.
13. Specify the output port. ( "Specifying the port" (p. 159))
14. If you are making an assignment for a button, specify the button mode.
( "Specifying the button mode" (p. 158))
The GM2 System On message has now been assigned.
142