Enable Password; Ip Authorized Manager - Supermicro SSE-G48-TG4 Configuration Manual

1.2.3 Enable Password

Passwords for different enable levels can be configured by the switch administrator using the enable
password command.
Follow the steps below to enable password for any privilege level.
Step Command
Step 1 configure terminal
enable password [level (1-15)] <LINE
Step 2
password>
Step 3 end
The enable password configuration is saved automatically as part of the start-up
configuration. Enable password configuration is not displayed with the 'show running config'
command.
The "no enable password [level (1-15)]" command disables the enable password
parameters.
The example below shows the commands used to configure enable password.
SMIS# configure terminal
SMIS(config)# enable password level 10 pwd1

1.2.4 IP Authorized Manager

Supermicro switches allow configuration of IP authorized managers. This feature
the switch by using IP addresses to authorize computers to:
Access the switch's web browser interface
•
Telnet into the switch's console interface
•
Use SNMP or SSH
•
Follow the steps below to configure the authorized managers for the switch.
Step Command
Step 1 configure terminal
Description
Enters the configuration mode.
'enable'
Configures password for a particular
privilege level.
Level – Specify 1-15 for any of the
privilege levels
LINE enable password – Alphanumeric
Exits the configuration mode.
Description
Enters the configuration mode.
Supermicro L2/L3 Switches Configuration Guide
enhances security on
12