Speed - Supermicro SSE-G48-TG4 Configuration Manual

Gi0/19 not connected Full
Gi0/20 not connected Full
Gi0/21 not connected Half
Gi0/22 not connected Full
Gi0/23 not connected Half
Gi0/24 not connected Half
Ex0/1 not connected Full
Ex0/2 not connected Full
Ex0/3 not connected Full

1.4.3 Speed

Interface speed can be configured for physical interfaces when auto negotiation is disabled.
1Gb RJ45 interfaces can be configured to operate at 10Mbps, 100Mbps or 1000Mbps speed.
10Gb interfaces in SSE-G24-TG4, SSE-G48-TG4, SBM-GEM-X2C, SBM-GEM-X2C+ and SBM-GEM-X3S+
switches can operate only at the fixed 10Gb speed.
10Gb interfaces in SSE-X24S, SBM-XEM-X10S, SSE-X3348S and SSE-X3348T switches can be configurable
to operate at 1Gb or 10Gb speed.
40Gb interfaces are fixed to operate only at the 40Gb speed.
Follow the steps below to configure the interface speed.
Step Command
Step 1 configure terminal
Step 2 interface <interface-type><interface-id>
or
interface range <interface-type><interface-id> ....
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps No-Negotiation
1 Gbps Auto
1 Gbps Auto
10 Gbps No-Negotiation
10 Gbps No-Negotiation
10 Gbps No-Negotiation
Supermicro L2/L3 Switches Configuration Guide
Description
Enters the configuration mode.
Enters the interface
mode.
interface-type – may be any of the
following:
gigabitethernet – gi
extreme-ethernet – ex
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the "interface range ..." command. To
provide a range, use a hyphen (-)
configuration
22