Management Ip Address - Dhcp Configuration; Default Ip Gateway - Supermicro SSE-G48-TG4 Configuration Manual

1.1.2 Management IP Address – DHCP Configuration
Supermicro switches can be configured to obtain the management IP address through the DHCP
protocol. In this case, a switch acts as a DHCP client and obtains the IP address for any DHCP server on
the LAN.
Follow the steps below to obtain the management interface IP address dynamically from a DHCP server.
Step Command
configure terminal
Step 1
Step 2 ip address dhcp
Step 3 end
show ip interface
Step 4
The IP address dhcp configuration is saved automatically as part of the start-up
configuration.
The "no ip address dhcp" command disables the configuring of the management interface
IP address through the DHCP server.
The example below shows the commands used to configure the management interface IP address
through DHCP.
SMIS# configure terminal
SMIS(config)#ip address dhcp
SMIS(config)# end

1.1.3 Default IP Gateway

To configure the default gateway IP address in blade switches, follow the steps below.
Step Command
Step 1 configure terminal
ip gateway <ip-address>
Step 2
Step 3 end
Step 4 show ip interface
Description
Enters the configuration mode.
Configures the management interface
IP address through the DHCP server.
Exits the configuration mode.
Displays the management interface IP
configuration.
Description
Enters the configuration mode.
Configures the IP gateway address.
ip-address – IP address of a directly
connected router.
Exits the configuration mode.
Displays the interface IP configuration.
Supermicro L2/L3 Switches Configuration Guide 8