System Location - Supermicro SSE-G48-TG4 Configuration Manual

Time zone offset not set

1.6.3 System Location

Supermicro switches provide an option to configure the switch location details.
Follow the steps below to configure system location.
Step Command
Step 1 configure terminal
Step 2 system location <location name>
Step 3 end
Step 4 show system information
Step 5 write startup-config
The System Location configuration is automatically stored as part of the startup-
configuration file.
The example below shows the commands used to configure system location.
SMIS# configure terminal
SMIS(config)# system location "Santa Clara"
SMIS(config)# end
SMIS# show system information
Switch Name: SMIS
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: http://www.supermicro.com
System Location: Santa Clara
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf
Config Save IP Address: 0.0.0.0
Description
Enters the configuration mode.
Configures the system location.
location name – Location of the switch
specified as a string with a maximum
size of 256.
Exits the configuration mode.
Displays
configuration.
Optional step – saves this configuration
to be part of the startup configuration.
Supermicro L2/L3 Switches Configuration Guide
the system location
42