Console Log - Supermicro SSE-G48-TG4 Configuration Manual

LogBuffer(0 Entries)
LogFile(0 Entries)

1.7.3 Console Log

System Logging messages can be displayed in the switch console.
Follow the steps below to enable the Syslog console.
Step Command
Step 1 configure terminal
Step 2 logging console
Step 3 end
Step 4 show logging
Step 5 write startup-config
The "no logging console" command disables console logging.
The example below shows the commands used to enable the Syslog console.
SMIS# configure terminal
SMIS(config)# logging console
SMIS(config)# end
SMIS# show logging
System Log Information
----------------------
Syslog logging: enabled(Number of messages 0)
Console logging: enabled(Number of messages 0)
File logging: disabled(Number of messages 0)
Log File Name:
File Max Entries: 500
TimeStamp option: enabled
Trap logging: Critical
Log server IP: None
Facility: Default (local0)
Buffered size: 50 Entries
LogBuffer(0 Entries)
LogFile(0 Entries)
Description
Enters the configuration mode.
Enables Syslog console.
Exits the configuration mode.
Displays the Syslog configuration.
Optional step – saves this configuration
to be part of the startup configuration.
Supermicro L2/L3 Switches Configuration Guide 54