Duplex Operation - Supermicro SSE-G48-TG4 Configuration Manual

Gi0/6 not connected Full
Gi0/7 not connected Full
Gi0/8 not connected Full
Gi0/9 not connected Full
Gi0/10 not connected Full
Gi0/11 not connected Full
Gi0/12 not connected Full
Gi0/13 not connected Full
Gi0/14 not connected Full
Gi0/15 not connected Full
Gi0/16 not connected Full
Gi0/17 not connected Full
Gi0/18 not connected Full
Gi0/19 not connected Full
Gi0/20 not connected Full
Gi0/21 not connected Half
Gi0/22 not connected Full
Gi0/23 not connected Half
Gi0/24 not connected Half
Ex0/1 not connected Full
Ex0/2 not connected Full
Ex0/3 not connected Full

1.4.4 Duplex Operation

Supermicro switches support configuring physical interfaces to full-duplex or half-duplex operation.
Follow the steps below to configure the duplex operation type.
Step Command
configure terminal
Step 1
Step 2 interface <interface-type><interface-id>
or
interface range <interface-type><interface-id> ....
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
1 Gbps Auto
10 Mbps No-Negotiation
1 Gbps Auto
1 Gbps Auto
10 Gbps No-Negotiation
10 Gbps No-Negotiation
10 Gbps No-Negotiation
Supermicro L2/L3 Switches Configuration Guide
Description
Enters the configuration mode.
Enters the interface
mode.
interface-type – may be any of the
following:
gigabit ethernet – gi
extreme-ethernet – ex
interface-id is in slot/port format for all
physical interfaces.
configuration
24