Analyzer Id - Teledyne T200H User Manual

Operating Instructions

4.11.4. ANALYZER ID

SAMPLE A1:NXCNC1=100PPM
< TST TST > CAL
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK MORE
106
Each type of Teledyne API analyzer is configured with a default ID code. The default
ID code for all T200H/M analyzers is either 0 or 200. The ID number is only important
if more than one analyzer is connected to the same communications channel such as
when several analyzers are on the same Ethernet LAN (see Section 4.11.7); in a RS-232
multidrop chain (see Section 4.11.9) or operating over a RS-485 network (see Section
4.11.6). If two analyzers of the same model type are used on one channel, the ID codes
of one or both of the instruments needs to be changed so that they are unique to the
instruments. To edit the instrument's ID code, press:
NOX=XXX.X
SETUP
EXIT
Toggle these buttons
to cycle through the
available character set:
0-9
The ID can be any 4 digit number and can also be used to identify analyzers in any
number of ways (e.g. location numbers, company asset number, etc.)
Teledyne API - Model T200H/T200M Operation Manual
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 COM2
SETUP X. MACHINE ID: 200 ID
0 2 0 0
EXIT
ENTR button accepts the
new settings
EXIT key ignores the new
ENTR EXIT
07270D DCN7141
settings