Setup  Acal: Automatic Calibration (Autocal) - Teledyne T200H User Manual

Teledyne API - Model T200H/T200M Operation Manual
Press NEXT of PREV to move back
and forth through the following list
of Configuration information:
• MODEL NAME
• SERIAL NUMBER
• SOFTWARE REVISION
• LIBRARY REVISION
• iCHIP SOFTWARE REVISION
• HESSEN PROTOCOL REVISION
• ACTIVE SPECIAL SOFTWARE
1
OPTIONS
• CPU TYPE
• DATE FACTORY CONFIGURATION
SAVED
1
Only appears if relevant option of feature is active.
4.6. SETUP  ACAL: AUTOMATIC CALIBRATION (AUTOCAL)
07270D DCN7141
SAMPLE
< TST TST > CAL
SAMPLE
CFG DAS RNGE PASS CLK MORE
1
1
SAMPLE
NEXT
Instruments with one of the internal valve options installed can be set to automatically
run calibration procedures and calibration checks. These automatic procedures are
programmed using the submenus and functions found under the ACAL menu.
A menu tree showing the ACAL menu's entire structure can be found in Appendix A-1
of this manual.
Instructions for using the AUTOCAL feature are located in the Section 5.8 of this
manual along with all other information related to calibrating the T200H/M analyzer.
A1:NXCNC1=100PPM
PRIMARY SETUP MENU
T200 NOX ANALYZER
PREV
Operating Instructions
NOX=XXX.X
SETUP
Press EXIT at
any time to
return to the
EXIT
SAMPLE display
Press EXIT at
any time to
return to
EXIT
SETUP menu
77