Hydraulic Specifications - Genie GTH-5519 Service And Repair Manual

September 2016
Hydraulic Specifi cations
Hydraulic Oil Specifi cation
Hydraulic oil type
Viscosity grade
Viscosity index
Cleanliness level,
minimum
Water content,
maximum
Chevron Rando HD oil is fully compatible and
mixable with Shell Donax TG (Dexron III) oils.
Genie specifications require hydraulic oils which
are designed to give maximum protection to
hydraulic systems, have the ability to perform over
a wide temperature range, and the viscosity index
should exceed 140. They should provide excellent
antiwear, oxidation, corrosion inhibition, seal
conditioning, and foam and aeration suppression
properties.
Part No. 1272852
Chevron Rando HD equivalent
Multi-viscosity
200 ppm
Optional fl uids
Biodegradable
Fire resistant
200
Mineral based
15/13
NOTICE
Note: Use Chevron Aviation A hydraulic fluid when
ambient temperatures are consistently below
0°F / -17°C.
Note: Use Shell Tellus T46 hydraulic oil when oil
temperatures consistently exceed 205°F / 96°C.
Genie specifications require additional equipment
and special installation instructions for the
approved optional fluids. Consult the Genie
Service Department before use.
Continuous improvement of our products
is a Genie policy. Product specifi cations are
subject to change without notice.
GTH-5519
Section 2 • Specifications
SPECIFICATIONS
Petro Canada Environ MV46
Statoil Hydra Way Bio Pa 32
BP Biohyd SE-S
UCON Hydroluble HP-5046
Quintolubric 822
Shell Tellus S2 V 32
Shell Tellus S2 V 46
Chevron Aviation A
Continued use of Chevron Aviation
A hydraulic fluid when ambient
temperatures are consistently
above 32°F / 0°C may result in
component damage.
Eni Arnica 32
2-3