Operator's Compartment - Genie GTH-5519 Service And Repair Manual

Section 3 • Repair Procedures

Operator's Compartment

2-1
Operator's Compartment
How to Remove the Operator's
Compartment
The operator's compartment is used to activate
machine functions while sitting in the operator's
drivers seat.
Within the operator's compartment there is a
transmission column shifter, steering selector,
4-way controller, accelerator pedal and brake
pedal. All of these components are replaceable.
For further information or assistance, consult the
Genie Service Department.
Bodily injury hazard. This
WARNING
procedure requires specific
repair skills, lifting equipment
and a suitable workshop.
Attempting this procedure
without these skills and tools
could result in death or serious
injury and significant component
damage. Dealer service is
required.
1 Start the diesel engine and raise the boom
above the cab.
2 Open the engine cover and disconnect the
battery negative (-) terminal. battery negative (-) terminal.
Electrocution/burn hazard.
WARNING
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
3-12
and disconnect the
GTH-5519
3 Remove the protective cover next to the cab -
inner side of the machine.
4 Cut the plastic fasteners fixing the electrical
cables, then disconnect all of the electrical
wires.
5 5 Tag, disconnect and plug the hydraulic lines Tag, disconnect and plug the hydraulic lines
of: power steering, power steering delivery, of: power steering, power steering delivery,
solenoid valve delivery, tank draining, brake solenoid valve delivery, tank draining, brake
pump, power steering delivery from pump, pump, power steering delivery from pump,
joystick (no.6). joystick (no.6).
Bodily injury hazard. Spraying
WARNING
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
6 Tag, disconnect and plug the heater lines (n.2
hoses).
7 Disconnect the ground wire.
8 Remove the 4 retaining fasteners of the cabin.
9 Install and secure two eyebolts to the top the
cabin in the special seats.
September 2016
Part No. 1272852