Printer Does Not Print - Ricoh AP306 Printer Reference

Printer Does Not Print

Possible cause
Is the power on?
Does the On Line indica-
tor stay on?
Does the Error indicator
stay red?
Is the paper set?
Is the specified paper size
correct?
Is the specified paper type
correct?
Is the interface cable be-
tween the printer and the
computer connected se-
curely?
Are you using a correct in-
terface cable?
Did you connect the inter-
face cable after turning on
the power switch?
When you print using the
RICOH-SCRIPT2 printer
driver in a network, data
is received by the printer,
but is not printed.
Solutions
If not, confirm that the power cord is securely plugged
into the power outlet and the printer.
Turn on the printer.
the printer
If not, press {On Line} to make it light up.
If so, check the error message on the panel display and
take the required action.
on the Operation Panel"
Load paper into the paper tray or on the bypass tray.
P.30 "Loading Paper"
Set the specified paper size in any of the input trays.
Set the specified paper type in any of the input trays.
Connect the interface cable properly. If there are any con-
nectors or screws, confirm that they are fastened securely.
For more information about the settings, see the "Quick
Installation Guide".
The type of interface cable you should use depends on the
computer. Be sure to use the correct one.
If the cable is damaged or worn, replace it with a new one.
For more information about the settings, see the "Quick
Installation Guide".
Connect the interface cable before turning on the power
switch.
Windows 95/98
On the [PostScript] tab of the Printer Properties, click
[Advanced] and then clear both [Send CTRL+D before job]
and [Send CTRL+D after job].
Windows 2000
On the [Device Settings] tab of the Printer Properties, se-
lect [No] for both [Send CTRL-D Before Each Job:] and
[Send CTRL-D After Each Job:].
Windows NT 4.0
Open the [Advanced] tab of the Printer Properties. From
[PostScript Options], select [No] for both [Send CTRL-D Be-
fore Each job:] and [Send CTRL-D After Each job:].
Printer Does Not Print
the "Setup Guide" that comes with
P.38 "Error & Status Messages
4
49