Figure 18. Configuring A Single Device - Sonim XPi User Manual

Using the Intel® Device Management Service

Figure 18. Configuring a Single Device

The configurable fields are:
Name: To change the device name click 'Edit' enter your new device name and
•
click 'Save' to save the change.
• Sensor Status: Toggle the Sensor Status button to the desired position
(ON/OFF) to enable/disable a sensor.
Reporting Interval: To change the Reporting interval, enter the desired value in
•
the dialog box and select Minutes/Hours/Days from the dropdown. Minimum
Reporting Interval is 5 minutes.
• Sensor Reading Frequency: To change the Sensor Reading Frequency, enter
the desired value in the dialog box and select Minutes/Hours/Days from the
dropdown. Minimum Sensor Reading Frequency is 5 minutes.
4. Once the required changes have been made, click 'Apply' to save the new
configuration.
Note: If the Sensor Reading Frequency is set too low relative to the Reporting Interval,
you may lose data as older readings are overwritten by new ones. A maximum 90
sensor readings can be stored before they are overwritten.
Choosing settings that can lead to data loss generates a warning to users as shown in
Figure 19. Settings that would queue over 90 readings for a sensor in a reporting
interval, thereby causing data loss, cannot be saved. The Apply button on the screen is
grayed out, as shown in Figure 19. However the calculation used does not account for
M2X upload failures or network connection failures. To enable the Apply button, the
configuration needs to be changed to within the intervals noted above.
December 2017
Document Number: 336569 Rev 1.0
Sonim* XPi
User Guide
27