Power On The Device; Power Off The Device; Charge The Device; Wake Up The Device - Sonim XPi User Manual

Using the Sonim XPi
Table 2. Sonim* XPi Characteristics
Size
Weight
Certifications
Operating
temperature
Storage
temperature
3.1

Power on the Device

There are 2 ways to power on the device:
• Press and release the Power Button
OR
• Connect the device to a power supply (5V) via the Micro USB connector
After approximately 6 seconds, the User LED flashes white 3 times to indicate the
device is powering up. See Figure 6.
If the User LED flashes red 3 times, the device is already ON.
If the device is connected to a power supply, the Power LED is green.
•
• If the device is running on battery, NO LED is illuminated.
The device stays awake for 20 seconds after power-on or waking up.
Note:
3.2

Power off the Device

Press and hold the Power Button for 10 seconds, until the Red LED stops flashing.
If the device was powered on by connecting to a power supply, it powers off when it is
disconnected.
3.3

Charge the Device

The device can be charged with a 5 V/0.5 A power supply and Micro USB Cable,
purchased separately.
The Charge Status LED is RED until it is fully charged, at which time the LED turns off.
3.4

Wake Up the Device

The device goes to sleep between sensing intervals. You may want to wake the device
to force a configuration update and, if there is buffered data, a sensor upload to M2X.
December 2017
Document Number: 336569 Rev 1.0
101mm x 57mm x25mm
Sonim XPi: 126 g
Expansion GNSS Sensor Board: 42g
Sonim XPi + Expansion GNSS Sensor Board: 164 g
FCC PTCRB
Charging temperature: 0 to 60
Discharging temperature: -20
°
For a month: -20 C to 45
°
For 6 months:+15 C to +25
°
C
° °
C to 60 C
°
C
°
C
Sonim* XPi
User Guide
15