3.0
Using the Sonim XPi
Devices are partially charged and ready to be activated. Be sure to charge it fully before
use. By default, all sensors are enabled and the default interval for data upload is 15
minutes. For more information, refer to the
Figure 6. Sonim XPi device
The atmospheric pressure and temperature sensors need to access outside air.
These sensors are placed near the enclosure edge of the Sonim XPi device with 2 holes
between the Power Button and the USB Charging Port (See Figure 1). The holes allow
outside air to enter. A mesh behind the holes restricts fluid ingress but allows airflow.
Be careful not to cover the two small holes on the device between the Power Button
Note:
and USB Charging port. Doing so can affect sensor readings.
Sonim* XPi
User Guide
14
Configure Device(s)
section.
Document Number: 336569 Rev 1.0
Using the Sonim XPi
December 2017