Figure 17. Devices Menu - Sonim XPi User Manual

A. The default value of the 'Name' field is the device Serial Number. This can be edited
to a more user-friendly name.
B. RSSI is enabled by default and cannot be disabled. The RSSI is measured when a
network connection is established, based on the selected reporting interval, power
on and manual sensor upload.
C. Battery On Charge Indicator is not directly configurable using the Intel® DMS UI and
takes its configuration from the Battery Charge Level. If the Battery Charge Level on
Intel® DMS is disabled, no values are reported to the 'Charging' stream on M2X.
Possible Values for the Battery Charge Indicator are ON (1) or OFF (0).
D. The default reporting Interval is 1 hour.
E. The default Sensor Reading Frequency is 15 minutes.
F. All sensors are enabled by default (ON).
G. The 'Reset to Factory Default' button resets your device sensor and upload interval
settings to the default settings.
Note: 'Reset to Factory Default' button has no effect on the device name setting.
4.2.3.2 Configure a Single Device
To custom configure your devices individually:
1. Log in to the Intel® Device Management System (Intel® DMS) using your AT&T IoT
Platform Account credentials.
2. From the Devices screen, click the device name to see data for one device.

Figure 17. Devices Menu

3. Select the Device to be configured by clicking the 'Device Name' on the 'Devices'
tab.
Sonim* XPi
User Guide
26
Using the Intel® Device Management Service
Document Number: 336569 Rev 1.0
December 2017