Cleaning And Disinfection - AGFA CR 10-X User Manual

Cleaning and Disinfection

All appropriate policies and procedures should be followed to avoid
contamination of the staff, patients and device. All existing universal
precautions should be taken to avoid that the digitizer and its accessories
come into contact with potential contaminations. Details about cleaning can
be found in the following pages.
To clean the exterior of the digitizer:
1. Switch off the digitizer.
2. Remove the power plug from the socket.
Switch off the UPS, if installed.
3. Wipe the exterior of the digitizer with a clean, soft, damp cloth.
Use a mild soap or detergent if required but never use ammonia-based
cleaner.
4. Plug the power plug into the socket.
Switch on the UPS, if installed.
Cleaning the cassette adapter
To clean the cassette adapter:
Wipe the cassette adapter with a clean, soft, damp cloth. Use a mild soap
or detergent if required but never use ammonia-based cleaner.
CAUTION:
Damage or deterioration of safety provisions can cause
injury of the operator.
Remove the power plug from the socket before cleaning the
exterior of the device.
CAUTION:
Make sure no liquid gets in the digitizer.
Note: Do not open the digitizer for cleaning. No components
inside the digitizer require cleaning by the user.
CR 10-X, CR 12-X, CR 15-X | Introduction | 29
2491E EN 20150409 1543