Rigid Pipe Venting Systems - Regency Bellavista B36X Owners & Installation Manual

The minimum components required for a basic horizontal termination using 4" x 6-5/8" are:
1 Rigid Pipe Adaptor
1 Reducer
1 90 o Elbow
1 Wall Thimble
1 Length of pipe to suit wall thickness
1 Horizontal Termination Cap
Wall thickness is measured from the back standoffs to the inside mounting surface of termination cap. For siding other than vinyl furring strips may
be used, instead of the vinyl siding standoff, to create a level surface to mount the vent terminal. The Terminal must not be recessed into siding.
Measure the wall thickness including furring strips.
If a Vinyl Siding Standoff is required (it must be used with vinyl siding), measure to outside surface of wall without siding and add 2 inches.
A
Vertical
Termination
Cap
Storm Collar
Flashing
Ceiling Firestop
Pipe Length
90 Elbow
Pipe
Length
Reducer
(4" x 6-5/8" venting)
43"
(1092 mm)
Rigid Pipe Adaptor
The FPI AstroCap and FPI Riser Vent terminal are certifi ed for installations using FPI venting systems as well as Simpson Dura-Vent
TM
American Metal Products, Security Secure Vent
Ltd. Dura-Vent® and Direct Vent are registered and/or proprietary trademarks of Simpson Dura-Vent Co. Inc.
Regency Bellavista™ B36X Gas Fireplace

RIGID PIPE VENTING SYSTEMS

Horizontal or Vertical Terminations
Vinyl Siding
Standoff (Optional)
Wall Thimble
Pipe Length
o
, AmeriVent Direct Vent. AstroCap
®
B
Astrocap
(946-523/P)
(279mm)
WARNING:
Do not combine venting components from
different venting systems.
Exception: However, use of the AstroCap
FPI Riser is acceptable with all systems.
This product has been evaluated by Intertek for
using a Rigid Pipe Adaptor in conjunction with
DuraVent Direct Vent, Selkirk Direct-Temp, Ameri
Vent Direct venting and Security Secure Vent
systems. Use of these systems with the Rigid
Pipe Adaptor is deemed acceptable and does not
affect the Intertek WHI listing of components.
is the proprietary trademark of FPI Fireplace Products International
TM
INSTALLATION
ASTROCAP # 946-523/P
DIMENSIONS
11"
(279mm)
11"
Direct Vent,
®
and
TM
25