Table of Contents
Advertisement
2. INITIAL SETUP
2.2
Initial Setup for TZTL12F/TZTL15F
1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Radar] from the [Settings] menu.
3. Tap [Radar Source], then select the appropriate antenna unit.
Note: If the antenna unit is connected but does not appear in the [Radar Source]
list, close the list and open it again. The name of the antenna unit should appear
with a check mark, as in the example below.
4. Drag the [Radar] menu display the menu item [Radar Initial Setup], then tap
[Radar Initial Setup].
5. Referring to the tables below, set up the radar.
[Radar] menu - [Radar Initial Setup]
Menu item
[Antenna Rotation]
[Antenna Heading Align]
[Main Bang Suppression]
[Enable Sector Blanking]
[Enable Sector 2 Blanking]
[Radar] menu - [Antenna Position]
Menu item
[Longitudinal (from bow)]
[Lateral (-Port)]
[Antenna Height]
[Auto Tuning]
[Tuning Source]
[Manual Tuning]
[Radar Monitoring]
[Radar Optimization]
[ARPA Advanced Settings]
[Set Hardware To Factory
Default]
[Reset Default Settings]
RDxxxxxx - DRS6A X-Class
Select the antenna rotation speed.
See "How to align the antenna heading" on page 18.
If main bang appears at the screen center, slide the circle
icon so that the main bang disappears, while watching the
radar echo at the left-hand side of the display.
Up to two sectors may be selected for blanking (no trans-
mission). Select [ON] to enable this feature. Set the start
and end angles (0° to 359°).
Referring to the figure on the right, enter the ra-
dar antenna positioning bow-stern (Longitudi-
nal) and port-starboard (Lateral) position from
the origin.
Select the height of the antenna above the waterline.
Enable/disable auto tuning for the connected radar.
Select the range to tune.
Manually tune the radar. Not available when [Auto Tuning]
is enabled.
Display various information regarding the connected ra-
dar.
Automatically adjust magnetron output and tuning for the
connected radar. Do not change these settings.
Do not change these settings.
Resets the radar selected at [Radar Source] to factory de-
fault.
Resets [Radar] menu settings to default.
Description
Description
Origin
Origin
Advertisement
Table of Contents
