Initial Setup For Tzt9/Tzt14/Tztbb - Furuno DRS6A X-Class Installation Manual

2. INITIAL SETUP
WARNING
The radar antenna emits
electromagnetic radio frequency (RF)
energy which can be harmful,
particularly to your eyes. Never look
directly into the antenna aperture
from a close distance while the radar
is in operation.
Distances at which RF radiation levels
of 100, 50 and 10 W/m
in the table below.
Radiator
XN10A
XN12A
XN13A
The DRS6A X-Class is compatible with the FURUNO Multi Function Displays and soft-
ware version combinations shown below. The combination with other models may not
operate properly.
• TZT9, TZT14, and TZTBB: Version 4.21 or later (Planned release: Middle of 2016)
• TZTL12F and TZTL15F: Version 3.01 or later (Planned release: Middle of 2016)
Turn on the antenna unit and FURUNO Multi Function Display. Initial setup for this an-
tenna must be done on the FURUNO Multi Function Display.
2.1

Initial Setup for TZT9/TZT14/TZTBB

1. Press the Home key (or tap the Home icon).
2. Select [Menu] on the menu icon bar to open the main menu.
3. Select [Radar].
4. Select [Radar Source] on the [Menu Radar] sub menus, then select the radar type
connected.
Note: If the antenna unit is connected but does not appear in the [Radar Source]
list, close the list and open it again. The name of the antenna unit should appear
with a check mark, as in the example below.
2
exist are given
2 2
100 W/m 50 W/m 10 W/m
0.1 m 0.5 m
N/A 0.4 m
N/A 0.2 m
Before turning on the radar, be sure
no one is near the antenna.
Prevent the potential risk of being
struck by the rotating antenna, which
can result in serious injury or death.
2
3 m
2.2 m
1.9 m
RDxxxxxx - DRS6A X-Class
RDxxxxxx - DRS6A X-Class
WARNING