Furuno DRS6A X-Class Installation Manual page 16

1. INSTALLATION AND WIRING
3. Wrap the junction of the connectors with self-vulcanizing tape and vinyl tape (local
supply) for waterproofing as follows:
1) Wrap the junction of the connectors
with one layer of self-vulcanizing
tape.
3) Wrap one layer of the vinyl tape over
the self-vulcanizing tape.
4. As shown in the figure below, secure the ground wire from the ship's ground (IV-
2sq, local supply) and ground wire from the antenna unit, using the terminal screw
(M4x10) that is pre-attached to the cable cover.
Ground wire* from
the antenna unit
5. Apply silicone rubber to the ground terminal after fastening the terminal screw.
Self-vulcanizing tape
Vinyl tape
Terminal screw*
Cable cover
2) Change wrap direction and wrap
one layer of the self-vulcanizing
tape again.
Self-vulcanizing tape
4) Change wrap direction and wrap one
layer of the vinyl tape again.
Vinyl tape
Ground wire from
the ship's ground
*: Pre-attached to the cable cover.
Silicone rubber