Table of Contents
Advertisement
2. INITIAL SETUP
5. Drag the [Menu Radar] sub menus to find the menu item [Radar Initial Setup].
Title
6. Set the items referring to the table shown below
Menu item
[Antenna Rotation]
[Antenna Heading Align]
[Main Bang Suppression]
[Enable Sector Blanking]/
[Enable Sector Blanking2]
[Antenna Height]
[Antenna Longitudinal Po-
sition]
[Antenna Lateral Position (-
Port)]
[Auto Tuning]
[Tuning Source]
[Manual Tuning]
[Radar Monitoring]
[Radar Optimization]
[ARPA Advanced Settings] Do not change these settings.
Menu Radar (Radar Initial Setup)
Select the antenna rotation speed.
See "How to align the antenna heading" on page 16.
If main bang appears at the screen center, slide the circle
icon, while watching the radar echo on the left-side of the
display, until the main bang disappears.
Up to two sectors may be selected for blanking (no trans-
mission). Select [ON] to enable this feature. Set the start
and end angles (0° to 359°).
Select the height of the antenna above the waterline.
Enter the antenna positioning bow-stern
(Longitudinal) and port-starboard (lateral)
position from the origin.
Enable/disable auto tuning for the connected radar.
Select the range to tune.
Manually tune the radar. Not available when [Auto Tuning]
is enabled.
Display various information regarding the connected ra-
dar.
Automatically adjust magnetron output and tuning for the
connected radar. Do not change these settings.
Description
Origin
Advertisement
Table of Contents
