Furuno DRS6A X-Class Installation Manual page 15

1.6 Wiring
Wiring considerations
• Turn the power at the switchboard off before beginning the wiring.
• The cable assembly and power/LAN cables have connector(s). Do NOT cut the ca-
ble assembly and power/LAN cables even if the cables are run through a radar
mast.
• When you replace the DRS4A/6A/12A/25A with the DRS6A X-Class, the existing
cable cannot be used. Use only the cable assembly supplied with the DRS6A X-
Class.
1. Unfasten two screws to remove the cable cover.
2. Connect the cable assembly (supplied) to the power/LAN cable that is pre-at-
tached to the antenna unit.
Cable assembly
Cable cover Cable cover
1. INSTALLATION AND WIRING
Power/LAN cable:
Pre-attached to the antenna unit.