Initial Setup; Check Points After Installation - Furuno DRS4D-NXT Installation Manual

2.

INITIAL SETUP

2.1

Check Points After Installation

Before using the product, carry out the following:
• Mechanical checks
• Turning the power on and initial setup
Mechanical checks
Check below points before switching on the DRS4D-NXT.
• All washers are in place and bolts are fully fastened.
• All connections are secure and network cable is connected to the multi function dis-
play device.
• All connecting cables and wires are secured as instructed on page 4.
Turning the power on and initial setup
Use the information in this manual and the manual for multi function display device to
power the sensor and to proceed with initial setup.
1. Ensure that all personnel are clear of the antenna.
2. Press and hold down the power key of your multi function display device until the
unit is ON.
3. Take the appropriate action on your multi function display device to turn on the
DRS4D-NXT.
4. Check if the heading is correctly aligned - targets should appear at their correct
bearing relative to the boat's bow. Adjust the alignment if necessary, referring to
section 2.2.
2.2 Initial Setup
Turn on the multi function display device, and do the initial setup for the antenna unit.
2.2.1 Initial setup for NavNet TZtouch2 (TZTL12F/TZTL15F)
1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Radar] from the [Settings] menu.
3. Tap [Radar Source], then select the appropriate antenna unit.
Note: If an antenna unit is connected but does not appear in the [Radar Source]
list, close the list and open it again. The name of the antenna unit should appear
with a check mark, as in the example below.
xxxxxxxx-xxxxxxxxxx
8