Furuno DRS6A X-Class Installation Manual page 43

1. INSTALLATION AND WIRING
7. Apply silicone rubber to the holes and bolts at the locations indicated with arrows
in the figure below. Also apply silicone rubber to the junction between the radiator
and the radiator bracket.
Bolt assembly - side view (detailed)
Spring
washer
Hex. bolt
1.5 Mounting the Antenna Unit
The antenna unit can be mounted using the fixing holes on the outside (200 200 mm)
or inside (140
When 140
side fixing holes.
1. Set the supplied mounting template to the mounting location, then drill four fixing
holes in the mounting location.
Note: The holes must be parallel with the fore and aft line.
Mounting template
2. Attach four corrosion-proof rubber pads (supplied) to the mounting holes.
Radiator
Flat washer
Silicone rubber
150 mm) the antenna unit. Normally, use the outside fixing holes.
150 mm fixing holes already exist on the mounting platform, use the in-
Bow Bow
Apply silicone
rubber to these
bolts and holes
Radiator - bottom view
Corrosion-proof rubber pad
Apply silicone rubber Apply silicone rubber
to the junction to the junction
between the radiator between the radiator
and radiator bracket. and radiator bracket.