Edit A Memory Channel - AOR AR-DV10 Operating Manual

7.5.

EDIT A MEMORY CHANNEL

A memory channel which already contains a saved frequency, can be edited as follows:
1. Press [MENU] and use the [▶] button to move to [MEM] and press [ENT]
2. Use the [▶] button to move to [CH EDIT] and press [ENT] twice.
3. Use the keypad to enter the bank number and channel number, followed by [ENT].
For example: [0110] + [ENT] for bank 01 and channel 10.
4. To edit any of the parameters, just use the [▶] button to highlight the parameter to be
changed, then press [ENT] to edit each one as follows:
BANK-CH: Use the keypad to enter the bank number and
channel number, followed by [ENT].
Example: [0110] + [ENT] for bank 01 and
Use the keypad to enter the frequency in MHz,
FREQ:
followed by [ENT].
Rotate the dial selector knob to select the
MODE:
desired modulation type, then press [ENT].
Rotate the dial selector knob to select the
IFBW:
desired IF bandwidth, then press [ENT].
Rotate the dial selector knob to toggle the
PASS:
frequency PASS, ON or OFF, then press
[ENT]. If set to ON, this memory channel will
be ignored when the memory bank is
scanned.
Input a name as described in chapter 10.3
T:
"INPUT CHARACTERS & SYMBOLS".
PROTECT: Rotate the dial selector knob to toggle
PROTECT,
[ENT]. If set to ON, this memory channel
cannot be erased (refer to page 2/2).
Rotate the dial selector knob to choose from
SQL N/L:
LEVEL, NOISE or AUTO squelch.
SQL TYPE: Rotate the dial selector knob to choose from
CTCSS, DCS, Reverse Tone and OFF.
Rotate the dial selector knob to set the
CTCSS:
CTCSS tone frequency to Manual, Automatic
Discovery Mode (SRCH), or OFF.
: Rotate the dial selector knob to set the DCS
DCS CODE
tone code to Manual, Automatic Discovery
Mode (SRCH), or OFF.
Rotate the dial selector knob to set automatic
AGC:
gain control to FAST, MID, SLOW or RF-G.
Set the offset frequency function as described in chapter 10.8 "OFFSET
OFFSET F.:
RECEPTION".
channel 10.
ON or OFF, then press
31