Table of Contents
Advertisement
7.8.
SCAN A GROUP OF LINKED MEMORY BANKS
Select the scan group of linked memory banks to be
scanned:
1.
Press [MENU], use the [▶] button to select [SCAN], then
press [ENT].
2.
Use the [▶] button to select [GRP], then press [ENT].
3.
Input the scan group number with the keypad, then
press [ENT].
Start scanning this group:
1.
Press [MENU], then use the [▶] button to select [SCAN]
and, then press [ENT].
2.
Press [ENT] again.
7.9.
COPY/ERASE/MOVE CHANNELS, BANKS AND GROUPS
Copy, move, and erase the contents of memory channels, memory banks and scan groups
as follows:
1.
Press [MENU].
2.
Use [▶] to select [EDIT], then press [ENT].
3.
Use [▶] to select the data COPY, MOVE or ERASE
category.
MEM CH: For just a single memory channel.
MEM BANK: For an entire memory bank.
SCAN GRP: For a scan group.
4.
Press [ENT] and rotate the dial selector to chose either:
COPY:
To copy data
MOVE:
To move data (the original will be lost)
DEL:
To delete data
5.
Press [ENT] to save the data input screen.
6.
Using the dial knob, select the data to be erased, copied
or to be moved to the target location, and then move to
the next selection with the [▶] key.
7.
When all the data is entered, initiate the copy, move, or
erase procedure by selecting: [XXX EXEC] and then
press [ENT].
◯「WRITING MEMORY...」will be displayed for a short time until the procedure is
completed.
34
Advertisement
Table of Contents
