Assign Titles To Memory Banks; Create A Group Of Linked Memory Banks - AOR AR-DV10 Operating Manual

Set the voice descrambler function as described in chapter 10.6 "ANALOG
V.SCR:
VOICE DESCRAMBLER".
Finally save all the settings: Use the [▶] button to go to the line 9, [MEM CH PARAM
5.
SET] and press [ENT].
7.6.

ASSIGN TITLES TO MEMORY BANKS

A title may be assigned to each memory bank, and PROTECTON set, so the bank is not
accidentally erased.
1. Press [MENU], use the [▶] button to select [MEM] and then press [ENT].
2. Use the [▶] button to select [BANK EDIT] and then press [ENT].
3. To edit any of the parameters, just use the [▶] button to highlight the parameter to be
changed, then press [ENT] to edit as follows:
Input a bank title as described in chapter 10.3 "INPUT CHARACTERS &
T:
SYMBOLS".
PROTECT: Rotate the dial selector knob to toggle PROTECT, ON or OFF, then press [ENT].
If set to ON, this memory bank cannot be erased.
4. Finally save all of the settings: Use the [▶] button to move to line 9, [MEM CH PARAM
SET] and press [ENT].
7.7.

CREATE A GROUP OF LINKED MEMORY BANKS

There are 10 scan groups (numbered 0 to 9) that may be set up individually to scan a group
of linked memory banks. Each scan group can be setup with its own squelch behavior as
follows:
Delay time, is the pause after the signal drops until the squelch closes and scan
resumes.
Free time, is the time after which scanning will resume, whether or not the signal is
interrupted.
32