Powering With Alcaline Batteries - AOR AR-DV10 Operating Manual

Hide thumbs Also See for AR-DV10:

Table of Contents

If the AC power adapter is connected to the fast charger cradle, when the receiver is

inserted into the cradle, the cradle's LED will first turn red, indicating a charging status.

When the battery pack is fully charged, the LED will turn green.

A flashing red LED indicates a charging error. If this occurs, please check the following:

・ Inspect the battery pack and charger cradle electrodes for any contamination or

obstructive object.

・ The battery pack might be over-discharged. A totally discharged battery pack cannot be

charged using the cradle. In that case connect the AC power adapter directly to the

receiver to charge the battery pack for about 10 minutes. Then continue the charge as

usual through the charger cradle.

3.3.

POWERING WITH ALCALINE BATTERIES

The supplied alkaline battery tray allows operation of the receiver using six "AA" size

alkaline battery cells.

Important：：：：

・ The battery tray must NOT be used with rechargeable cells, as it does not contain the

thermal and over-current protection circuits required when utilizing Ni-Cd and Ni-MH

cells!

When installing the alkaline batteries, insert the (-) end first, then press in the (+) end so

the battery snaps into place. Pay attention to the polarity indicated inside the tray.

Insert (-) ends first.

Alkaline battery tray BT-10

Table of Contents