Table of Contents
Advertisement
Create a scan group:
1.
Press [MENU], use the [▶] button to select [SCAN], then press [ENT].
2.
Use the [▶] button to select [GRP EDIT], then press [ENT] twice.
3.
Enter the scan group number to be created, with the keypad.
This illustration shows an example of scan group 0 and
all bank numbers from 00 to 39 which can be linked,
providing they already have frequencies registered.
4.
Press the [▶] button followed by [ENT], that will select
the first bank 00 (the selected bank will blink).
For Example: to link banks 00 and 01:
5.
Press the [.] key to register bank 00.
6.
Use the [▶] button to move to bank 01 then press the [.]
key to register bank 01. (You can also rotate the dial
selector knob to rapidly scroll through the bank num-
bers)
If another bank number is selected by mistake, it may be deselected with the [.] key.
The linked banks 00 and 01 will appear as follows:
00 01
02 03 04 05 06 07 08 09
10 11 12 13 14 15 16 17 18 19
20 21 22 23 24 25 26 27 28 29
30 31 32 33 34 35 36 37 38 39
7.
Press the [9] key to save the bank link selection and move to the following settings for
[DELAY TIME].
Delay time:
Is the time after the signal drops until the squelch closes, and scan resumes.
Delay time can be set between 0.1 and 10 seconds, in 0.1 second increments.
[OFF] is no delay.
Default is 2 seconds.
Press [ENT] and rotate the dial knob to select the desired timing.
Press [ENT] to Validate the setting. The following setting [FREE] is now selected.
Free time:
Free time, is the time after which scanning will resume, whether or not the signal is
interrupted.
Free time can be set between 1 and 60 seconds.
[OFF] means scanning will resume only after the signal drops, as set in "Delay time".
Default is [OFF].
8.
Press [ENT] and rotate the dial knob to select the desired timing.
9.
Press [ENT] to validate the setting.
10. Press [ENT] to save all the settings of this group link page.
33
Advertisement
Table of Contents
